|
BE2 has specially designed
for excellent bass sound effect with simple and easy installation
for any Electric Bass guitars. It features Bass, Treble, Balance
and Volume knobs are on-board with Battery hole in center could
eliminate unnecessary spaces and wires. Using advanced Surface
Mount Technology could reduce unwanted sound (Noise) while increasing
sound quality and it's reliability. High Impedance Input design
can match with any Active or Passive Pickups and also Low Impedance
Output will keep the same tone from your guitar to any amplifier
system without losing high frequency response. Installation is a piece of cake!
Connect two wires from two pickups into
PCB and then three wires in between Output Jack. The last step,
connect the Ground wire. Now here you go! Another great concern for the installation, semi-fixed
potentiometer could increase BE2's flexibility for the precise aperture
requirement. Each band has up to 12 dB of cut and boost.
ARTEC guarantees a virtually noiseless sound with long 9 V battery
life. (More
than 4000 hours in continuous use. - workable voltage : drop down
to 6 V). Technical
Specifications : Bass
: +/-12 dB at 100 Hz, Treble : +/-12 dB at 4 kHz,
Current : 0.16 mA Voltage range : 6 V ~ 22 V Battery
: 9 V Alkaline |