SE2 BASS, TREBLE CONTROL EQUALIZER
SE2 features a pre-wired balance control and
master volume and treble on separate potentiometers with the bass
on SMT PCB. Each control pots are designed to connect to PCB
by a connector, which make SE2 installation easier and versatile.
Additional wiring you may need for SE2 installation is just Pickup,
Output Jack, Ground and Battery cable. High Impedance Input
design can match with any Active or Passive Pickup and also Low
Impedance Output will keep the same tone from your guitar to any
PA system without losing high frequency response. Using advanced
Surface Mounted Techniques could reduce unwanted sound (Noise) while
increasing sound quality and it's reliability. ARTEC guarantees a virtually noiseless sound with
long 9V battery life.
SE2-A features SE2 with Concentric
Potentiometer, which is Bass and Treble eq's on one pot
and mounted on SMT PCB.
(more than 4000
hours in continuous use. - workable voltage : drop down to
6 V).
Application : Electric Basses, Electric guitars
& Piezo pickup equipped instruments.
|